air in clutch
Posted: Sat Feb 01, 2020 11:08 am
i'm not sure whats going wrong?
Back ground- epb failure -caliper seized -replaced brake caliper- bled barkes all good hard.parking brake set and working fine
so while i had some brake fluid left i bled the clutch as was a bit soft before.
i use a gunson 1 man pressure kit (worked fine on the barkes)with low pressure 8bar from the spare wheel .i get air from bleeding the clutch then when i think its ok i try the pedal and its still soft .so i try again and more air and the same outcome .tryed again and put grease around the bleed nipple and pretty much the same result.
Obviously i need to do this different or maybe there is something wrong ? where is the air getting in ?there are no fluid leaks!
Any ideas otherwise i have to take it to garage?
i have read reverse bleeding but i dont know if that will make any difference maybe something is wrong?
Back ground- epb failure -caliper seized -replaced brake caliper- bled barkes all good hard.parking brake set and working fine
so while i had some brake fluid left i bled the clutch as was a bit soft before.
i use a gunson 1 man pressure kit (worked fine on the barkes)with low pressure 8bar from the spare wheel .i get air from bleeding the clutch then when i think its ok i try the pedal and its still soft .so i try again and more air and the same outcome .tryed again and put grease around the bleed nipple and pretty much the same result.
Obviously i need to do this different or maybe there is something wrong ? where is the air getting in ?there are no fluid leaks!
Any ideas otherwise i have to take it to garage?
i have read reverse bleeding but i dont know if that will make any difference maybe something is wrong?